[an error occurred while processing this directive] 404

 

 

 

Sorry, the page you requested was not found.

 

If you're having trouble locating a destination on VMware.com, try visiting the VMware Homepage.

 

 

404

 

 

 

Sorry, the page you requested was not found.

 

If you're having trouble locating a destination on VMware.com, try visiting the VMware Homepage.

 

 

Installing Guest Operating Systems

previous Prev   Contents   Last   Next next

SuSE Linux 8.0 Installation Guidelines

SuSE Linux 8.0 Installation Guidelines

Support

Support

This guest operating system is supported on the following VMware products:

  • VMware Workstation 4.0
General Installation Notes

General Installation Notes

The easiest method of installing SuSE Linux 8.0 in a virtual machine is to use the standard SuSE distribution CDs. The notes below describe an installation using the standard distribution CD; however, installing SuSE Linux 8.0 via the boot floppy/network method is supported as well.

Before installing the operating system, be sure that you have already created and configured a new virtual machine.

Note: During the SuSE Linux 8.0 installation, do not install an X server. To get an accelerated SVGA X server running inside the virtual machine, install the VMware Tools package immediately after installing SuSE Linux 8.0.

Installation Steps

Installation Steps

  1. Insert the SuSE Linux 8.0 installation CD in the CD-ROM drive and click the Power On button.
  2. Follow the installation steps as you would for a physical machine until you get to the selection screens described in the next steps.
  3. Install using the text mode installer.
  4. When prompted, do not install an X server. In the Configure Monitor screen, choose No X11. The installer asks you to confirm. Click Continue and finish the installation.
  5. At the end of the installation, install VMware Tools in your guest operating system. For details, see VMware Tools below.

This completes basic installation of the SuSE Linux 8.0 guest operating system.

VMware Tools

VMware Tools

Be sure to install VMware Tools in your guest operating system. For details, see the manual for your VMware product. Do not start the X server in the guest operating system until you install VMware Tools.

Note: When you start installing VMware Tools (by typing ./vmware-install.pl in the vmware-tools-distrib directory), the following message appears:

Found an installed version of the VMware SVGA driver for XFree86 4. Some versions of this driver included with the XFree86 4 distributions do not work properly. Would you like to install a stable (but possibly older) version of the driver over the currently installed one?

If you plan to dual-boot the virtual machine, answer Yes to allow the driver to be installed. Answer Yes again to back up the existing video driver files and also copy the XF86Config-4.dist file to XF86Config-4.vm. The latter file is used when dual-booting the virtual machine.

If you do not intend to dual-boot the virtual machine, answer No to keep the existing driver.

Before You Start the X Server

Before You Start the X Server

After you have installed VMware Tools, but before you start the X server, as root user, run the SaX2 configuration utility to configure your X server. At a command prompt, type SaX2 and use the wizard to configure your X server.

After you run SaX2 you may boot your SuSE 8.0 virtual machine with any of the selections offered in LILO.

Known Issues

Known Issues

Guest Screen Saver

Guest Screen Saver

On a Linux host with an XFree86 3.x X server, it is best not to run a screen saver in the guest operating system. Guest screen savers that demand a lot of processing power can cause the X server on the host to freeze.

previous Prev   Contents   Last   Next next

404

 

 

 

Sorry, the page you requested was not found.

 

If you're having trouble locating a destination on VMware.com, try visiting the VMware Homepage.