[an error occurred while processing this directive] [an error occurred while processing this directive]
VMware

VMware Workstation 3.2

Features | Documentation | Knowledge Base | Discussion Forums

previous Prev   Contents   Last   Next next

Disk Performance in Windows NT Guests on Multiprocessor Hosts

Disk Performance in Windows NT Guests on Multiprocessor Hosts

Some users have seen slower than expected disk input/output performance when running Windows NT guest operating systems in a VMware Workstation virtual machine using IDE virtual disks on a multiprocessor host computer. The I/O issue is especially noticeable when the virtual machine is booting.

Improving Performance

Improving Performance

You may increase performance by enabling DMA (direct memory access) on the virtual hard disk's IDE channel in the virtual machine.

Note: You should not enable DMA on the IDE channel to which you have attached your virtual DVD/CD-ROM drive. In most cases, the virtual hard disk is attached to IDE channel 0 and the virtual DVD/CD-ROM drive is attached to IDE channel 1, so this is not an issue.

If you have a virtual disk and a DVD/CD-ROM attached as master and slave to the primary IDE controller (channel 0) and you want to enable DMA, power off the virtual machine and use the Configuration Editor (Settings > Configuration Editor) to move the DVD/CD-ROM drive to the secondary IDE controller (channel 1) at IDE 1:0.

You can enable the DMA feature after you finish installing Windows NT. You must install Service Pack 3 or higher in the virtual machine to enable this option.

Once the virtual machine is running Windows NT, insert an SP3 or SP4 CD in the drive and run DMACHECK.EXE from the \SUPPORT\UTILS\I386 folder on the CD. Or download DMACHECK.EXE from the Microsoft Web site
(support.microsoft.com/support/kb/articles/Q191/7/74.ASP).

Click the Enabled option for the IDE controller and channel configured for the virtual disk. Typically, this is channel 0 only, unless you have the virtual machine configured with multiple virtual disks and no virtual DVD/CD-ROM drive.

As noted above, you should not enable DMA on an IDE channel with a virtual DVD/CD-ROM drive attached.

previous Prev   Contents   Last   Next next