[an error occurred while processing this directive] [an error occurred while processing this directive]
VMware

VMware Workstation 3.2

Features | Documentation | Knowledge Base | Discussion Forums

previous Prev   Contents   Last   Next next

SuSE Linux 7.0 Installation Guidelines

SuSE Linux 7.0 Installation Guidelines

The easiest method of installing SuSE Linux 7.0 in a virtual machine is to use the standard SuSE distribution CDs. The notes below describe an installation using the standard distribution CD; however, installing SuSE Linux 7.0 via the boot
floppy/network method is supported as well.

Before installing the operating system, be sure that you have already created a directory for the new virtual machine and configured it using the VMware Workstation New Virtual Machine Wizard (on Windows hosts) or Configuration Wizard (on Linux hosts).

Note: During the SuSE Linux 7.0 installation, a standard VGA16 X server (without support for the VMware Workstation X server) should be installed. To get an accelerated SVGA X server running inside the virtual machine, install the VMware Tools package immediately after installing SuSE Linux 7.0.

Installation Steps

Installation Steps

  1. Use the VMware Workstation Configuration Editor to verify the virtual machine's devices are set up as you expect before starting the installation. For example, if you would like networking software to be installed during the SuSE Linux 7.1 installation process, be sure the virtual machine's Ethernet adapter is enabled and configured. Be sure the virtual machine's memory is set to at least 64MB. VMware also recommends that you disable the screen saver on the host system before starting the installation process.

  2. Insert the SuSE Linux 7.0 installation CD in the CD-ROM drive and click the Power On button.

  3. Use the graphical installer and follow the installation steps as you would for a physical machine.

  4. In the Desktop Settings screen, select 640x480 256 colors.

  5. Finish installing SuSE Linux 7.0 as you would on a physical machine.

VMware Tools

VMware Tools

Be sure to install VMware Tools in your guest operating system. For details, see Installing VMware Tools.

Known Issues

Known Issues

  • On a Linux host with an XFree86 3.x X server, it is best not to run a screen saver in the guest operating system. Guest screen savers that demand a lot of processing power can cause the X server on the host to freeze.
  • When you are installing SuSE Linux 7.0 in text mode and the guest operating system reboots for the first time, the Linux boot sequence reaches "Keytable US," then the display turns completely black and the guest appears to be hung.

    Despite its appearance, the guest operating system actually is not hung; instead, the screen is not being displayed. To see the screen and continue with the installation, in the guest operating system, switch to Linux virtual console 2. Press Ctrl-Alt, press and release the spacebar, then press F2.

    Then return to virtual console 1. Press Ctrl-Alt, press and release the spacebar, then press F1. You should be able to see the screen and continue installing the guest operating system.

    Note: If you are using a different hot-key combination, use that in place of Ctrl-Alt above.

    Note: This problem appears only when you install the guest operating system in text mode.

previous Prev   Contents   Last   Next next